Tiny Scales Instructions
We have had good luck printing the scales with the following settings:
We clean the printbed with alcohol between prints.
(Other settings might work better for your printer, feel free to experiment!)
The STL prints two parts, a base and the scales harp.
They require assembly after printing; a small vise is handy, but you could
do it by tapping lightly with a hammer or even using a desk drawer.
Take care that they assemble at 90 degrees to each other.
The number of scales you'll be able to print depends on the size of the print bed.
We are getting 12 units at a time on a 235mm (9-1/4") square glass (heated) printbed.